4.
If the WWAN antenna is not connected to the terminal on the WWAN module, a protective sleeve must be
installed on the antenna connector, as shown in the following illustration.
Reverse this procedure to install the WWAN module.
Solid-state drive
To remove the M.2 solid-state drive, use this procedure and illustration.
Table 5-5
Solid-state drive descriptions and part numbers
Description
Spare part number
1 TB, PCIe, TLC
L85348-002
512 GB, PCIe, TLC
L85360-002
512 GB, PCIe, TLC, self-encrypting drive (SED)
L85368-002
512 GB, PCIe, value
L85364-002
256 GB, PCIe, TLC
L85350-002
256 GB, PCIe, TLC, self-encrypting drive (SED)
M07245-002
256 GB, PCIe, value
L85354-002
128 GB, PCIe, TLC
M06792-001
Solid-state drive cover (included in Bracket Kit)
M08556-001
Before removing the solid-state drive, follow these steps:
1.
Prepare the computer for disassembly (see
Preparation for disassembly on page 32
2.
Remove the bottom cover (see
).
3.
Disconnect the battery cable from the system board (see
Remove the solid-state drive:
Component replacement procedures
39
