HP Elite x2 1012 G2, Maintenance And Service Manual

Page: 59 / 90

Fingerprint reader board
Description Spare part number
Fingerprint reader board (includes bracket) 924460-001
IMPORTANT: Make special note of each screw and screw lock size and location during removal and
replacement.
Before removing the fingerprint reader board, follow these steps:
1. Turn off the computer. If you are unsure whether the computer is off or in Hibernation, turn the
computer on, and then shut it down through the operating system.
2. Disconnect the power from the computer by unplugging the power cord from the computer.
3. Disconnect all external devices from the computer.
4. Remove the following components:
a. Kickstand (select products only) (see Kickstand on page 26 )
b. Back cover (see Back cover on page 29 )
c. Display panel (see Display panel on page 30 )
d. Battery (see Battery on page 32 )
e. Hall sensor board (see Hall sensor board on page 34 )
f. Kickstand hinges (see Kickstand hinges on page 35 )
g. Solid-state drive (see Solid-state drive on page 36 )
h. WLAN module (see WLAN module on page 38 )
i. WWAN module (see WWAN or GPS module (select products only) on page 40 )
j. Webcam (see Webcam on page 42 )
k. Microphone board (see Microphone board on page 43 )
l. Rear webcam (see Rear webcam on page 45 )
m. System board (see System board on page 47 )
n. POGO connector (see POGO connector on page 48 )
o. Fan (see Fan on page 49 )
Remove the fingerprint reader board:
CAUTION: Use care to prevent damaging the ZIF connector and ribbon cable.
1. Remove the fingerprint reader bracket(1).
Component replacement procedures 51