5.
On the Modify Kernel Module: estape page, for
Next Boot State
, select the “static” radio button.
Check the box entitled
Backup
to create a backup copy of the existing kernel:
Figure 4 Adding estape driver to the kernel
.
6.
If you wish, type in a Reason for Change, such as “
Initial estape installation May
1st 2007
” and then select the
Modify
tab.
7.
Click the
OK
button at the Operation Successful page. Both
estape
and
stape
drivers will now
be shown with
Next Boot State
as “static”.
8.
For media changers, use a similar procedure to prepare the
eschgr
(with
schgr
) module.
9.
From the right-hand panel on the Kernel Configuration page, click
View Pending Changes and
reboot
and proceed to reboot the system as directed.
10.
Following the reboot ,re-run SMH and search again for the driver as in step 3 above.
Current
State
and
Next Boot State
should both be listed as “static”.
Add device files
For HP-UX 11i v2
Use the
sam
utility to create device files.
sam
runs as a mouse-driven GUI (see
on a system with full graphics capability, or as a console text-based interface (see
If you use the text-based interface, use the Tab and arrow keys to navigate, and the Return key to
select.
1.
Enter
sam
at the command line:
% sam
HP (HP-UX) servers and workstations
12
