To replace the component, reverse the removal procedure.
Removing and replacing the cartridge
Procedure
1.
on page 23).
2.
on page 23), if necessary.
3.
Push latch on cover.
4.
Pull cover up and slide back.
5.
Press the cartridge latch buttons and open the latches.
6.
Remove the cartridge.*
To replace the component, reverse the removal procedure.
*Cartridges placed into slots 3 and 4 will appear upside down from image.
Cartridge components
For the following, see the cartridge user and maintenance guide on the Hewlett Packard Enterprise
website (
http://www.hpe.com/info/edgeline-docs
• Memory configuration and replacement
• Heatsink replacement
Removing and replacing the front panel board
Depending on your system configuration, perform one of the following procedures:
•
Remove and replace the front panel board for the PCIe configuration
•
Remove and replace the front panel board for the PXIe configuration
Remove and replace the front panel board for the PCIe configuration
Procedure
1.
on page 23).
2.
on page 23).
3.
Remove the fixed top cover (
Removing the fixed top cover of the PCIe system
on page 25).
4.
Using a Torx screwdriver, remove the four T-10 Torx screws and remove the front-end bezel.
32
Removing and replacing the cartridge
Summary of Contents for Edgeline EL4000
Page 18: ...18 Customer self repair ...
Page 19: ...Customer self repair 19 ...
Page 20: ...20 Customer self repair ...
Page 65: ...wireless wide area network Acronyms and abbreviations 65 ...
