To connect to the target system
The HP E2494A probe adapter connects to both the Pentium II Instrumented
Mobile Module, and the Pentium II Mobile Processor mounted on Intel’s
Instrumented Interposer board, using the 190-pin Mictor connector. The
probe adapter connects to both types of target systems in a similar manner.
You must have the appropriate board for connecting the HP E2494A to your
target system. For target systems using a Pentium II Mobile Module, a Pentium
II Instrumented Mobile Module is required. For target systems using a Pentium
II Mobile Processor, an Instrumented Interposer board is required. These
boards have the 190-pin Mictor connectors mounted on them. They are
available from Intel.
Connecting to Pentium II Instrumented Mobile Module systems
C A U T I O N
To protect your equipment, remove the power from both the preprocessor
interface and the target system before you make or break connections.
1
Remove the Pentium II Instrumented Mobile Module board from the
target system.
2
Connect the HP E2487A preprocessor interface cables to the
HP E2494A probe adapter, as shown on page 4.
C A U T I O N
Connecting the preprocessor interface cables to the probe adapter after the
probe adapter is already connected to the mobile module may exert
excessive stress on the mobile module and the probe adapter. Excessive
stress can damage the mobile module and/or the probe adapter.
To connect to the target system
5
