EL-MF877-00 Page 2
Template Revision C
Last revalidation date 09-May-2018
HPI instructions for this template are available at
Item Description
Notes
Quantity of
items
included in
product
Gas Discharge Lamps
NA
0
Plastics containing Brominated Flame Retardants
weighing > 25 grams (not including PCBs or PCAs
already listed as a separate item above)
NA
0
Components and parts containing toner and ink,
including liquids, semi-liquids (gel/paste) and toner
Include the cartridges, print heads, tubes, vent
chambers, and service stations.
0
Components and waste containing asbestos
NA
0
Components, parts and materials containing refractory
ceramic fibers
NA
0
Components, parts and materials containing
radioactive substances
NA
0
2.0 Tools Required
List the type and size of the tools that would typically be used to disassemble the product to a point where components and
materials requiring selective treatment can be removed.
Tool Description
Tool Size (if
applicable)
Description T15 screw driver (Disassemble 3 pcs screws for side bkt and main bkt)
T15 3.0~4.0
kgf-cm
Description T15 screw driver (Disassemble 3 pcs screws for ODD cage and main bkt)
T15 3.0~4.0
kgf-cm
Description T15 screw driver (Disassemble 2 pcs screws for PCI cover and main bkt)
T15 3.0~4.0
kgf-cm
Description T15 screw driver (Disassemble 4 pcs screws for MB and main bkt)
T15 3.0~4.0
kgf-cm
3.0 Product Disassembly Process
3.1 List the basic steps that should typically be followed to remove components and materials requiring selective treatment
including the required steps to remove the external enclosure:
1.
Loosen thumb screw and remove Access panel from hosing
2.
Pull off ODD SATA con &ODD power con.
3.
Remove ODD from hosing
4.
Remove front bezel.
5.
Loosen 3 screws on side bkt then remove it.
6.
Loosen 3 screws on front brkt then remove ODD cage.
7.
Pull off all cables on MB.
8.
Loosen 2 screws on Rear brkt then remove System Fan
.
9.
Loosen 2 screw on PCI cover then remove it.
10.
Remove VGA card from hosing.
11.
Loosen 4 screws on MB then remove it.
12.
Loosen 4 screws on PSU then remove it.
3.2 Optional Graphic. If the disassembly process is complex, insert a graphic illustration below to identify the items contained in the
product that require selective treatment (with descriptions and arrows identifying locations).
