HP Designjet 9000s Series, User Manual

Page: 12 / 392

12 User´s Guide
1.4 Connection oof tthe pprinter
The APS is installed to the printer connecting two hoses as
follows:
– Take the hoses and plug the end stubs on the
intake ports of the APS
Note:
The two hoses are fitted with a stub at one end.
– The other end of the hose is pushed through the
exhaust attachment flange of the printer and
mounted with a clamping hose.
Note:
The printer has on the left and right side respectively two
exhaust attachment flanges.
1.5 Power oon tthe A APS
Connect the APS as follows:
– Insert the plug of the power cable into the socket.
Ensure that the supply voltage matches that posted on the unit.
– Finally check again all connection for accuracy and tight fit.
The APS may be put into operation after all hose pipes have been connected and the connec-
tion checked.
1.6 Function ddescription
Suction hoses are connected directly between exhaust ports on the HP Designjet 8000s or
9000s/10000s printers and the APS.
The APS is switched on at its membrane keyboard.
Air containing volatile organic compounds from HP low-solvent inks released inside the HP Des-
ignjet 8000s or 9000s/10000s printers is removed through the hoses and brought into the fil-
ter casing and filter elements.
The filter element consists of the following filter levels:
– Pre-filter mat and activated carbon filter.
Purified air with volatile organic compounds trapped in the filter elements is drawn out by the
fan below the filter element and then passes through the exhaust grid in the sound absorption
module attached at the rear.