HP DESIGNJET 3D, Service Manual

Page: 375 / 458

-359
Part Measurement Equations
Use the equation table below to record part measurements. Refer to these
equations when entering values in HP Designjet 3D Diagnostic Software.
Front: _ ______ - ____ = ________
(A + B) + (B + C) - B
Right: _ ______ - ____ = ________
(C + F) + (F +I) - F
Left: _ ______ - ____ = ________
(A + D) + (D + G) - D
Rear: _ ______ - ____ = ________
(G + H) + (H + I) - H
Left Rear: _ ______ - ____ = ________
(C + E) + (E + G) - E
Left Front: _ ______ - ____ = _______
(A + E) + (E + I) - E
Figure 353: Part based calibration measurement locations