Remove the system board:
1.
Disconnect the audio board cable
(1)
, the Bluetooth module cable
(2)
, the USB cable
(3)
, and the
power cable
(4)
from the system board.
NOTE:
The power connector and the RJ-11 jack are held in place with double-sided tape and
can be removed after the cables have been detached from the system board.
2.
Remove the 3 Phillips PM2.5×6.0 screws that secure the system board to the base enclosure.
CAUTION:
Do not lift the system board by the optical drive expansion board
(1)
.
3.
Lift the right edge of the system board
(2)
until the external monitor port is clear of the base
enclosure. Then pull the board out of the base enclosure
(3)
.
Component replacement procedures
77
Summary of Contents for Compaq Presario CQ71
