Power Switch Assembly
1.
Prepare the computer for disassembly (
Preparation for Disassembly on page 31
).
2.
Remove the access panel (
Access Panel on page 32
).
3.
Remove the front bezel (
Front Bezel on page 33
).
4.
Place the chassis on its side with the rear toward you.
5.
Disconnect the braided cables from the system board.
6.
Free the braided cables from the cable tie that is attached to the chassis.
7.
Position the computer on its side with front toward you.
8.
Press down on the tab on the switch holder
(1)
, rotate the switch holder downward
(2)
, and then
pull it away from the chassis while guiding the wires through the hole in the chassis.
To install the power switch assembly, reverse the removal procedures.
Plug the cable into the black connector labeled JFP1.
Power Switch Assembly
49
