HP C1537A, Technical Reference Manual

Page: 14 / 62

14 HP Servers and Workstations — HP-UX 10.20 and 11.x
processor 0 62 processor CLAIMED PROCESSOR Processor
memory 0 63 memory CLAIMED MEMORY Memory
After you have installed the new tape drive, you can check that it has been
attached successfully. From a shell window (
hpterm/xterm
), execute
ioscan
to display the list of attached devices:
% /sbin/ioscan -C tape -fn
The new lines should look similar to the following, where the
4
in the
I
field
represents the instance of the SCSI tape driver, not the SCSI ID:
tape 4 2/0/1.5.0 stape CLAIMED DEVICE HP XXXXXX
where
XXXXX
is
C1537A
,
C1557A
,
C5683A
,
C5713A
or
C7438A
depending
on the type of drive.
If you cannot find the drive
, this may be because the kernel does not contain
the correct driver. U se the System Administration Manager (
sam
) to add
stape
to the kernel:
To add
stape
to the kernel using
sam
:
1
% sam
2 Select the following:
Kernel Configuration
Drivers
3 Highlight the
stape
driver. If the driver has not been added to the kernel,
both Current State and Pending State will read “Out”.
4
Select the following:
Actions
Add Driver to Kernel
The Pending State will now read “In”.
5 To add the new driver to the kernel, select:
Actions
Create a New Kernel
6 The
stape
driver will now be added to the kernel and then the system will
reboot.