Figure 80 Operations: Magazines page
Using the manual magazine release
1.
From the back of the Autoloader determine which magazine needs to be removed using
.
Figure 81 Manual magazine release holes
Right magazine release
1.
Left magazine release
2.
2.
Push a small metal pin or paper clip about 1.5 cm (0.6 inch) into the appropriate release hole
to push on the release latch (see
) while another person grasps the
magazine and removes it from the Autoloader.
Figure 82 Removing the left magazine
Insert a pin into access hole
1.
Release and remove the magazine
2.
IMPORTANT:
Do not force the pin once you encounter resistance. Doing so can damage
the Autoloader.
Removing and replacing the base chassis
In this process you will:
•
Record configuration settings.
•
Remove the tape cartridge from the tape drive.
134
Upgrading and servicing the Tape Autoloader
Summary of Contents for BL536A
Page 149: ...German laser notice Italian laser notice Japanese laser notice Laser compliance notices 149 ...
Page 151: ...Danish notice Dutch notice Estonian notice Finnish notice French notice Recycling notices 151 ...
Page 155: ...French battery notice German battery notice Battery replacement notices 155 ...
Page 156: ...Italian battery notice Japanese battery notice 156 Regulatory compliance and safety ...
