HP AdvanceStack 100VG, Installation Manual

Page: 14 / 26

7. Connect the appropriate 100VG network cable(s) to the
transceiver(s) installed in the module.
N o t e
There are some specific suggestions that you should observe when
connecting your switch to other 100VG networking devices. See the
Connectivity Quick Reference , included with the module, for 100VG
connection information.
8. Check the port LEDs for the newly-installed module to ensure that
the port(s) connected in the preceding step are up (the port is
enabled and has a good 100VG link).
If you have not already done
so, install the LED label strip for the 100VG module, as described
in step 1.
The “port-enabled’’ LED ( 1 , 2 ) will be lit for each port that
is up. The transmit (Tx) and/or receive (Rx) LEDs for each port that
is transmitting and/or receiving packets will flash when traffic is
detected on the port.
9. Customize the port configuration, if necessary. (See “Customizing the
Port Configuration” on the next page.)
10. Reboot the switch, since this is a new module being installed. (See
“Rebooting the Switch” on page 8 for more information on when the
switch must be rebooted.)
port-enabled LED
transmit LED
receive LED
1
Tx
Rx
2
Tx
Rx
Figure 5. Port LEDs for the Switch 100VG Module
6