Chapter 4
Removing and Replacing Components
Processor Extender Board
56
Replacing the Processor Extender Board
To replace the processor extender board, perform the following steps:
CAUTION
Your processor extender board may be used in either Itanium (IPF) or PA RISC processor based
systems. Ensure that the PA RISC/IPF dipswitch is set to PA RISC for proper functioning of
your system. See Figure 4-13 on page 55 for the correct dipswitch settings.
Step 1. Ensure the extraction levers are positioned in the outward, unlocked position.
Step 2. Align the processor extender board with the front and rear card guides.
Step 3. Slide the processor extender board down until it begins to seat in the socket located on the
midplane riser board.
Step 4. Push the extraction levers inward to the locked position in order to fully seat the processor extender
board into the socket on the midplane riser board.
Step 5. Replace the front cover.
Step 6. Replace the front bezel.
Step 7. If rack mounted, slide the HP Server into the rack until it stops.
