HP 780019-S01, Maintenance And Service Manual

Page: 17 / 105

Removal and replacement procedures 17
Before proceeding, verify the server is in standby mode by observing that the system power LED is
amber.
Extend the server from the rack
NOTE:
If the optional cable management arm option is installed, you can extend the server
without powering down the server or disconnecting peripheral cables and power cords. These
steps are only necessary with the standard cable management solution.
1.
Power down the server (on page 16 ).
2.
Disconnect all peripheral cables and power cords.
3.
Loosen the front panel thumbscrews.
4.
Extend the server on the rack rails until the server rail-release latches engage.
WARNING:
To reduce the risk of personal injury or equipment damage, be sure that the rack
is adequately stabilized before extending a component from the rack.
WARNING: To reduce the risk of personal injury, be careful when pressing the server
rail-release latches and sliding the server into the rack. The sliding rails could pinch your
fingers.
5.
After performing the installation or maintenance procedure, slide the server into the rack:
a.
Slide the server fully into the rack.
b.
Secure the server by tightening the thumbscrews.
6.
Connect the peripheral cables and power cords.
Remove the server from the rack
To remove the server from a Hewlett Packard Enterprise, Compaq branded, Telco, or third-party rack:
1.
Power down the server (on page 16 ).
2.
Extend the server from the rack (on page 17 ).
3.
Disconnect the cabling and remove the server from the rack. For more information, refer to the
documentation that ships with the rack mounting option.
4.
Place the server on a sturdy, level surface.