
6
Installing an OAP card
Installing and removing an OAP card
CAUTION:
The installation tools are not provided with the HP switches and OAP
cards.
This section describes the installation and removal of a firewall card on an
A5800-48G-PoE+ Switch with 2 Interface Slots (JC101A). The installation
and removal of other OAP card models are similar.
OAP cards are hot swappable. You can remove an OAP card from a
switch when the switch is powered on.
Prepare the following tools before installation:
•
Phillips screwdriver
•
ESD-preventive wrist strap
Install an OAP card
Follow these steps to install an OAP card:
Step1
Wear an ESD-preventive wrist strap, and make sure the wrist strap
makes good skin contact and is properly grounded.
Step2
Loosen the captive screws on the blank panel with a Phillips screwdriver,
as shown in
, and remove the blank panel from the slot to be
used. Keep the removed blank panel properly for future use.