HP 527, Quick Start Manual

Page: 4 / 23

Power Uplink Radio LAN (1 to 3) PoE Description
Steady green Any
Flashing
green
and
orange
alternatel
y
Any Any
Both 2.4GHz and 5GHz
radio interfaces are
transmitting or receiving
data.
Steady green Any Any Off Any
The uplink interface is
disabled or there is no
network activity.
Steady green Any Any Flashing green Any
The LAN interfaces are
active on a valid
1000Mbps link.
Steady green Any Any
Flashing
orange
Any
The LAN interfaces
are active on a valid
100Mbps link.
Steady green Any Any Any Off
No PoE device is
connected.
Steady green Any Any Any On A PoE device is connected.
Powering the HP 527
The HP 527 can be powered by using a local power source, an uninterruptible power
supply (UPS), a user-supplied power generator, or a PoE-enabled switch that provides
10/100 Mbps or 10/100/1000 Mbps Ethernet ports.
Before you connect power to the AP, verify that the power supply is steady.
The HP 527 supports an 802.3af PoE PSE connection to one device on LAN port 3.
This feature is dependent on the power source of the HP 527, as follows:
xx
Supports 802.3af class 1/2/3 PoE Out when the 803.3at (PoE+) power supply
mode is used.
x
Do not support PoE Out when the standard 803.3af power supply mode is used.
Important information to read before installing
Professional installation is required. For indoor installation only. Before installing or
using the AP, consult with a professional installer trained in RF installation and
knowledgeable in local regulations including building and wiring codes, safety,
channel, power, and license requirements for the intended country. The end user is
responsible for ensuring that installation and use comply with local safety and radio
regulations.
4