HP 3C509B-TP, Installation Manual

Page: 4 / 46

1 Connecting to a Netware 3.12 Server
Windows for Workgroups
4 Select “CONFIGURE NIC,” and verify the resource settings listed above
under the heading “Device Configuration.”
5 If changes are required, save those changes and exit.
6 Remove the 3com cards driver diskette and insert Netware client for DOS
and MS-Windows disk 1.
7 Execute INST_DOS.EXE and enter yes to accept the agreement if you are
using a Vectra VL8, then go directly to step 8.
If you are using a Vectra VL7 or VE7/VE8, complete the installation by
following the steps below.
A Specify the settings as listed below:
• C:\NWCLIENT
• Yes
• Yes
• C:\WINDOWS
• No
• 3Com Fast Etherlink/Etherlink III Bus Master2.
b Under the heading "Select the driver for your network board", insert
the 3Com 3C590 drivers disk and set the path to "A:\NETWARE\CLI-
ENT." (If you have an HP preloaded HDD, set path to "C:\Masters\Lan-
Drv\3C509\NWCLIENT\)
c Press "Enter" to continue the installation.
d When prompted, insert the corresponding disks to complete file
transfer and driver installation.
e When the install utility is finished, press <CRTL><ALT><DEL> to
restart the machine.
f After Windows loads, open the "NETWORK" folder, double-click the
"NETWORK SETUP" icon.
g Select "Networks", and verify that "Novell Netware (Workstation Shell
4.0 and above)" is listed under "Install Windows support for the
following network only:" and click on "OK."
8 Accept the default products by pressing enter, and then press “F10” to
continue.