24
Release Notes for the Cisco Catalyst Blade Switch 3020 for HP, Cisco IOS Release 12.2(55)SE and Later
OL-22861-04
Documentation Updates
•
CSCtj86299
If a static MAC address entry is configured for an IP address in the global routing table, ping
requests are sent through the global context, and replies are sent through Virtual Routing and
Forwarding (VRF). This is a VRF leak.
The workaround is to remove the static MAC address entry.
Documentation Updates
•
“Updates to the Software Configuration Guide” section on page 24
•
“Updates to the System Message Guide” section on page 25
•
“Updates to the Getting Started Guide” section on page 33
Updates to the Software Configuration Guide
In the “Configuring RIP for IPv6” section in the “Configuring IPv6 Unicast Routing” chapter, the task
table is incorrect. This is the correct table:
Command
Purpose
Step 1
configure terminal
Enter global configuration mode.
Step 2
ipv6 router rip
name
Configure an IPv6 RIP routing process, and enter router
configuration mode for the process.
Step 3
maximum-paths
number-paths
(Optional) Define the maximum number of equal-cost routes
that IPv6 RIP can support. The range is from 1 to 32, and the
default is 16 routes.
Step 4
exit
Return to global configuration mode.
Step 5
interface
interface-id
Enter interface configuration mode, and specify the Layer 3
interface to configure.
Step 6
ipv6 rip
name
enable
Enable the specified IPv6 RIP routing process on the interface.
Step 7
ipv6 rip
name
default-information
{
only |
originate
}
(Optional) Originate the IPv6 default route (::/0) into the RIP
routing process updates sent from the specified interface.
Note
To avoid routing loops after the IPv6 default route (::/0)
is originated from any interface, the routing process
ignores all default routes received on any interface.
•
only
—Select to originate the default route, but suppress all
other routes in the updates sent on this interface.
•
originate
—Select to originate the default route in addition
to all other routes in the updates sent on this interface.
Step 8
end
Return to privileged EXEC mode.
