Installing the 16Gb SAN Switch
For help identifying your specific enclosure setup and available connections, see the HP BladeSystem
c-Class Enclosure Setup and Installation Guide, provided with your enclosure, or the HP website
http://www.hp.com/go/bladesystem/documentation
Install the Brocade 16Gb SAN Switch into the enclosure:
1.
Locate the appropriate interconnect bay in the rear of the enclosure.
CAUTION:
Properly ground yourself before handling the switch.
NOTE:
Populate all enclosure interconnect bays with an interconnect module or one of the
blank panels provided.
2.
Press the handle latch to release the installation handle.
Figure 3 Releasing the installation handle
2. Handle latch
1. Installation handle latched position
3. Installation handle released
NOTE:
The Brocade 16Gb SAN Switch for HP BladeSystem c-Class is a hot-pluggable
device. The enclosure power may be on or off during installation.
3.
Align the Brocade 16Gb SAN Switch for HP BladeSystem c-Class with the appropriate
interconnect bay according to your enclosure’s specific configuration. Push the switch firmly
into the interconnect bay.
12
Setup
