382
If the connection is successfully established, the system notifies you to enter the username and
password. After entering the username (
client001
in this example) and password (
aabbcc
in
this example), you can enter the CLI of the server.
Publickey authentication enabled Stelnet server
configuration example
Network requirements
As shown in
, the switch acts as the Stelnet server, and it uses publickey authentication
and the RSA public key algorithm.
Establish an Stelnet connection between the host and the switch, so you can log in to the switch to
manage configurations.
Figure 101 Network diagram
Configuration procedure
In the server configuration, the client's host public key is required. Use the client software to generate
RSA key pairs on the client before configuring the Stelnet server.
There are different types of Stelnet client software, including PuTTY and OpenSSH. This example
uses an Stelnet client that runs PuTTY version 0.58.
The configuration procedure is as follows:
1.
Generate RSA key pairs on the Stelnet client:
a.
Run PuTTYGen.exe on the client, select
SSH-2 RSA
and click
Generate
.
Vlan-int2
192.168.1.40/24
Stelnet client
Stelnet server
Host
192.168.1.56/24
Switch
Summary of Contents for 10500 series
Page 326: ...312 No duration limit for this SA ...
