Individual Adjustment
Hands-On-Cycle 9/2022
11
Fig. 7:
1 - Leg rest :adjustment of length
2 - push rod: setting of length.
The inclination and length of the leg rest
can be adjusted.
Adjusting the inclination (see page 10, fig.
6): The screws of the two rear clamps can
be screwed either into the upper or lower
thread (7–9 Nm).
Adjusting the length: Loosen the screws of
all the 4 clamps that secure the leg rest to
the front boom. Adjust the leg rest to
your leg length. Tighten the fastening
screws again (7–9 Nm).
Adjustment of the leg rest mesh
The leg rest mesh can be attached in 2 po
-
siti
-
ons
Fig. 8: The leg rest mesh is fixed in front of the clamps.
Fig. 9: The leg rest mesh is fixed behind the clamps
Adjustment of the foot plates
Fig. 10: Leg rest with foot plate and lower leg fixation
1 - Fixation and adjustment of foot plates
2 - Fixation and adjustment of the lower leg fixation
You can move the foot plates sideways
and adjust the inclination. To do this, loos
-
en the fastening screws and tighten them
again after the adjustment (6 Nm).
Danger!
If the legs slip off the leg rest, they can
be rolled over. Your legs must rest se
-
curely on the leg rest and be secured
against falling off. Check whether you
need HP V
ELOTECHNIK
accessories for
this purpose (lower leg fixation, foot
plate).