19.
IMPORTANT:
Install all components with the same configuration that was used on the failed system board.
Install all components removed from the failed system board.
20.
Install the access panel.
21.
Install the power supplies.
22.
Power up the server.
23.
Ensure all firmware, including option cards and embedded devices, is updated to the same versions to
ensure that the latest drivers are being used.
24.
Re-enter any Secure Boot Keys that were previously added in the Secure Boot configuration.
25.
Re-enter the server serial number and the product ID (
Re-entering the server serial number and
on page 80).
Re-entering the server serial number and product ID
After you replace the system board, you must re-enter the server serial number and the product ID:
Procedure
1.
During the server startup sequence, press the
F9
key to access UEFI System Utilities.
2.
Select
System Configuration
>
BIOS/Platform Configuration (RBSU)
>
Advanced Options
>
Advanced System ROM Options
>
Serial Number
, and then press the
Enter
key.
3.
Enter the serial number and press the
Enter
key.
The following message appears:
The serial number should only be modified by qualified service personnel. This
value should always match the serial number located on the chassis.
4.
To clear the warning, press the
Enter
key.
5.
Enter the serial number and press the
Enter
key.
6.
Select
Product ID
.
The following warning appears:
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
7.
Enter the product ID and press the
Enter
key.
8.
To confirm exiting System Utilities, press the
F10
key.
The server automatically reboots.
HPE Trusted Platform Module 2.0 Gen10 Option
The HPE Trusted Platform Module 2.0 Gen10 Option is not a customer-removable part.
CAUTION:
If the TPM is removed from the original server and powered up on a different server, data stored in the
TPM including keys will be erased.
If you suspect a TPM board failure, leave the TPM installed and remove the system board (
on page 77). Contact a Hewlett Packard Enterprise authorized service provider
for a replacement system board and TPM board.
80
Re-entering the server serial number and product ID
Summary of Contents for ProLiant DL380
