
Warning : Read this manual carefully
before installing this pump.
This sign warns the user that
failure to follow an instruction may
damage the pump or the system
This sign warns the user of
important electrical safety
information.
Carefully store this manual.
If problems arise contact
Hozelock customer services.
Every Hozelock Flood Pump
is carefully tested and packed
during assembly.
On receipt, check that the pump has not
been damaged during transport. If the
pump is damaged, do not use, and
contact Hozelock customer services.
Check that the voltage and frequency
of pump shown on the rating label
corresponds to those available on the
mains.
ELECTRICAL INSTALLATION:
A 10MA OR 30MA RESIDUAL
CURRENT DEVICE (RCD)
MUST BE FITTED TO THE
MAINS SUPPLY.
PROTECT THE PLUG AND THE
POWER CABLE FROM HEAT,
OIL AND SHARP EDGES.
THE POWER CABLE SHOULD
ONLY BE REPLACED BY
QUALIFIED PERSONNEL.
MAKE SURE THAT
ELECTRIC CONNECTIONS ARE
PROTECTED FROM WATER
& SPLASHES
THE POWER CABLE SHOULD
HAVE A MINIMUM OF 3 CORE
0.75MM
2
SECTION EQUIVALENT
TO THAT OF H05 RN-F. TO
MAKE SURE THE PLUG IS
PROTECTED FROM ANY
SPLASHES, USE THE 10M CABLE
SUPPLIED TO CONNECT AS FAR
AWAY FROM THE PUMP AS
POSSIBLE
BEFORE USING THE PUMP,
ALWAYS INSPECT IT VISUALLY
(ESPECIALLY THE POWER CABLE
AND THE PLUG). DO NOT USE
THE PUMP IF IT IS DAMAGED.
NEVER USE THE POWER CABLE
TO LIFT THE PUMP.
The pump can be completely or partially
submersed and used to transfer clean or
dirty fluids.
This pump is not suitable to be
used in swimming pools, where
people can become immersed in
the water.
This pump is not suitable for table
fountains / aquariums / fountains /
filters for fish ponds / waterfalls.
If aquatic wildlife eg fish or frogs
could be present in the water, you
must take the required measure to
prevent them being sucked into the
pump.
The pump cannot be used for sea
water & inflammable, corrosive,
explosive or dangerous liquids.
The pump must never run dry.
The pump can handle max solids of
30mm. However this will be
reduced by the diameter of the
hose. eg 25mm hose may block if
solids greater than 25mm are
present
Limitations
Electrical Safety
General Safety
33800 FloodPump Inst 2/10/07 08:51 Page 4