© 2022 Hoymiles Power Electronics Inc. All rights reserved.
11
Single-phase Microinverter User Manual
5.6 Installation Step
Step 1. Attach Microinverter on Rail
A) Mark the approximate center of each panel on the frame.
B) Fix the screw on the rail.
C) Hang the microinverter on the screw (as
shown in the picture on the right), and
tighten the screw. The silver cover side
of the microinverter should be facing the
panel.
Step 2. Connect AC Cables of Microinverter
A) Plug the AC connector of the first
microinverter into the connector of
the second microinverter to form a
continuous AC branch circuit.
*Note: The length of AC cable on
microinverter is roughly 1.23 m, if the
distance between two microinverters is
more than the AC cable, please use an AC
extension cable between two microinverters
(as shown in the picture on the right).
B) Install the AC end cap on the open AC
connector of the last microinverter in the
AC branch circuit.
Step 3. Connect AC End Cable
A) Create the end cable
1. Separate the AC port into 3 parts.
Part 1
Part 2
Part 3
2. Insert the AC cable from Part 3 to Part 2,
and complete the wiring for the L, N
and Ground inside the Part 1 AC port
accordingly:
*Note: L: Brown wire
N: Blue wire
G: Yellow/Green wire
Please use 12 AWG cable as the AC end
cable.
Part 1
Part 2
Part 3
AC Cable
Coated with solder
3. Plug the AC port Part 2 into Part 1 once
the wiring is complete, then screw on
Part 3 to complete the AC extension
cable.