For more information call +44 (0)1744 886600 or visit
www.hoyles.com
Operation
When a call point is activated the call point LED will flash for at least 5 seconds and the Aidalarm
controller will give audible and visual indication, the Mains and 12V version should go into alarm
almost instantly but there may be a slight delay on the battery powered version due to power saving
measures.
Once the controller enters an alarm state a few seconds later the Overdoor light will give and audible
and visual indication.
Pressing the button on the controller in the centre of
the LED’s will silence the controller and remote
indicator but they will still give visual indication.
The system must be reset by using the reset button at the point of call.
If the system is not reset the main controller will give an audible indication every minute to signal
non-attendance.
If the call point is activated again before the system is reset, it will re-enter its full alarm state.
Battery monitoring and testing
When any unit is activated it sends is battery status back to the main controller, so it is recommended
that the system is activated and tested in full on at least a monthly basis.
The main controller monitors the battery of all remote devices and when it detects that one of the
units has a low battery it will beep and flash every three minutes.
It is recommended that all batteries are replaced at the same time every 12 months or sooner should
the low battery warning occur.
Order codes for replacement batteries:
A600WM/12 Kit
A600WBAT
1 x 3.6V D-battery
2 x 3V CR123 batteries
A600WB Kit
A600WBATB
2 x 3.6V D-battery
2 x 3V CR123 batteries
Individual
BAT-D-36
3.6V D-battery
BATCR123
3V CR123 Battery
Dwg 60305 Iss1 OCT 19
