For more information call +44 (0)1744 886600 or visit
www.hoyles.com
Wireless Set up
1. Remove power form all devices.
a. Ensure polarity is observed when inserting batteries as fitting them incorrectly will
damage the unit.
2.
A600W Aidalarm Controller
a. Place J3 in the PAIR position,
b. Apply power,
c. The PAIR LED with start to flash indicating it is ready to pair with other devices. The
controller can have up to 8 remote devices.
3.
S1600-W Pull Cord
a. Place J1 into the PAIR position,
b. Insert the battery observing polarity,
c. Pull the cord and LED1 will illuminate,
d. Move the J1 to ACTIVE and the LED will start to flash,
e. When the LED stops flashing the devices is paired with the controller.
4.
S1708W Reset Button
a. Place J1 into the PAIR position,
b. Insert the battery observing polarity,
c. Press the reset button and LED1 will illuminate,
d. Move the J1 to ACTIVE and the LED will start to flash,
e. When the LED stops flashing the devices is paired with the controller.
5.
S1778W Overdoor Light/Sounder
a. Place J1 into the PAIR position,
b. Insert the battery observing polarity,
c. When LED1 illuminates move the J1 to ACTIVE and the LED will start to flash,
d. When the LED stops flashing the devices is paired with the controller.
6. Once all remote devices are paired, move J3 on the
A600W
to the ACTIVE position and the
PAIR LED will extinguish, the system is now ready to use.
If the Aidalarm reaches its maximum of 8 remote devices it will automatically drop out of pair mode,
in this case move J3 to ACTIVE and the system is now ready to use.
To unpair all devices remove power from the
A600W
move J3 to PAIR and re-apply power.
To unpair an individual device, remove power from it, set the jumper to PAIR and re-apply power.
Dwg 60305 Iss1 OCT 19
