hoxter ABRA 6, Installation And Operating Instruction, Page: 8 / 16

SETTING UP THE PRODUCT AND COMMUNICATING CHANNEL
There is a red control diode RUN flashing.
Press the SET button on the control unit until the red control diode turns off.
Remove the strip between the battery and the contact in the display. It prevents
the batteries to power the display. In case, the display is already powered,
remove and after short moment put back inside all the batteries.
The first number from the product codes appears on the
display (list of product codes on page 13).
Scroll to the required number by short presses of the
SET
button. To confirm the selection hold the SET button for 5 sec.
Now the last two numbers from the product codes are active. Scroll to the
required number by short presses of the
SET button. To confirm the selection
hold the
SET
button for 5 sec.
Now the number of the communicating channel is active.
Confirm by holding the
SET
button. In case there is another
fireburning control installed or another source interfering the
communication, repeat the SET-UP process and choose
different channel.
Set message appears on the display to confirm the set-up
proces was finished succesfully. After a while the fireburning
control turns itself into operating mode.
SET-UP
SHORT PRESS TO CHANGE VALUE.
HOLD TO CONFIRM THE CHOICE.
1
2
3
4
5
6
7
8
RUN SET
S1 TK T1 12V DC
PWR
8