4- SHORT
SCREWS
HOWARD MILLER
MODEL 615010
ASSEMBLY INSTRUCTIONS
PARTS LIST:
8- LONG
SCREWS
1- CLOCK DIAL
ASSEMBLY
1- LARGE BASE RING
1- SMALL BASE RING
7. Hook the large curl of the third leg
around the small base ring.
4. Using the same procedure as in
steps 2 and 3, attach the second
leg, adjacent to the first leg.
5. Place the large base ring over the
outside of the legs, inside of the
small curls of the legs.
LARGE BASE RING
6. Place the small base ring inside of
the large curls of the two legs.
SMALL BASE RING
8. Lift the large base ring and slide
the small curl of the leg under the
ring.
9. Using a short screw attach the
third leg to the clock dial assembly.
1. Place the clock dial assembly
upside down on a soft clean
surface.
3. Using a short screw attach the leg
to the clock dial assembly.
2. Align the hole in the top (small curl
end) of
of the legs with one of
the four holes in the outside ring of
the clock dial assembly.
one
ALIGN
HOLES
4- RUBBER
PADS
1- GLASS TOP
(NOT SHOWN)
4- LEGS
NOTE: Do not completely tighten screws until all parts have been assembled, step 13.
Do not push or lean on the back of the dial when assembling.
