INSTALLING HOUGEN CUTTER IN ARBOR
1. Disconnect from power source.
2. Lay drill on its side with feed handles up or be sure Arbor clears table
if unit is in normal operating position.
3. Turn Feed Handles until cutter mounting set screws are exposed
and completely remove the set screw.
4. Insert proper pilot in shank end of Hougen Cutter.
5. Insert Hougen Cutter until flat on cutter shank is aligned with set
screw holes and is exactly perpendicular to axis of set screw holes.
6. Insert set screws and tighten.
OPERATION OF CUTTING FLUID RESERVOIR
1. With Drill in operating position, turn the feed handles
so that cutter and pilot are above the work surface.
2. Fill reservoir by removing cap on bottle.
3.
Turn on coolant bottle.
4. Test metering capabilities of Arbor/Cutter/Pilot assembly
(magnet ON-motor OFF) by feeding the Arbor gently
toward work surface until pilot is pushed up into Cutter,
thus allowing fluid to filter down onto work surface
through a groove in the pilot.
5. Fluid output can be adjusted by position of On/Off Valve.
On/Off Valve
8
