1. Produce the Correct size hole for the Tap you are
using.
2. Install the Tap-Matic unit using the instructions
above.
3. Position the machine so the Tap is centered and
just above the hole.
4. Applied Slick-Stik Lube or a alternative oil appro-
priate for tapping.
4. Lock the magnet in position and verify the Tap is
still centered over the hole.
5. Start the Motor using the Operating Instruction in
the Operators Manual.
10
10-32 X 1/2”
Stop Screw
With either system, verify that the 10-32 X 1/2” Stop Screw
(10648) is in place and tight.
Your 3-Jaw Chuck is now installed. Select the proper twist bit
for your application and follow Operating Procedures for the
Hougen Magnet Based Drill you are using.
6. Rotate the Feed Handles down until the Tap pulls
thru the material. Feed handles are not used to drive
the Tap down.
7. When the Tap-matic Assembly makes contact with
the Stop Screw the gears will disengage and the Tap
will stop turning.
8. While rotating Feed Handles to bring the Tap-Matic
UP, the Tap will engage and turn counter- clock-
wise.
9. Rotate the Feed Handles until the Tap is clear of
the work piece and push the Motor OFF button.
MOTOR
10937 TAPPING ATTACHMENT KIT
Set-Screw
Spindle Adapter
Approx. 1.625”
3.875” when the Motor is in the UP position
with 4” of stroke down.
Magnet
Tapping Attachment
Included in the Kit
Approx. 6”
OPERATING THE TAPPING ATTACHMENT