5
Hougen Manufacturing, Incorporated warrants its Portable Magnetic Drills and its Electro-hydraulic Hole Punchers for a period
of 1 year and other products for ninety (90) days from date of purchase against defects due to faulty material or workmanship
and will repair or replace (at its option) without charge any items returned. This warranty is void if the item has been damaged
by accident or unreasonable use, neglect, improper service, or other causes not arising out of defects in material or workman-
ship. No other expressed warranty is given or authorized. Hougen Manufacturing, Inc. disclaims any implied warranty of
MERCHANTABILITY or FITNESS for any period beyond the expressed warranty and shall not be liable for incidental or
consequential damages. Some states do not allow exclusions of incidental or consequential damages or limitation on how long
an implied warranty lasts and, if the law of such a state governs your purchase, the above exclusion and limitation may not
apply to you. This warranty gives you specific legal rights and you may also have other rights which vary from state to state.
To obtain warranty service, return the item(s), transportation prepaid, to your nearest Factory Authorized Warranty Repair
Center or to Hougen Manufacturing, Inc., 3001 Hougen Drive, Swartz Creek, Michigan 48473.
Hougen Drills are warranted against manufacturing defects only. Subject to Hougen Manufacturing inspection.
THIS WARRANTY IS IN LIEU OF ANY OTHER WARRANTY, EXPRESSED OR IMPLIED, INCLUDING ANY
WARRANTY OF MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE.
© 2013 Hougen Manufacturing, Inc.
Commercial / Industrial Limited Warranty
Photographs and Specifications shown are accurate in detail at time of printing. Manufacturer reserves the right to make improvements
and modifications without prior notice. Hougen, Rotabroach, and Hougen-Edge are proprietary trademarks of Hougen Manufacturing Inc.
UNPACKING YOUR NEW MAGNETIC DRILL
INSTALLING THE HOUGEN CUTTER
1. Open shipping carton and remove the literature and
hardware packages.
2. Read and follow all Instructions before attempting
to operate your new Magnetic Drill.
3. Complete and mail the Product Registration Card
NOW. It is important that Hougen Manufacturing, Inc.
have a record of product ownership.
4. Open hardware package and check contents.
10565 1/8" Allen Wrench for Gib Adjustment
10569 Feed handles (3)
04532 Feed handle knobs (3)
10727 3/16" Allen Wrench for reversing feed handle.
10730 Safety Chain
10779 7/32" Allen Wrench for cutter installation
13013 5/32" Allen Wrench for arbor installation
5. Using the handle of the Magnetic Drill, lift unit out of
the shipping case.
6. Remove all packing and securing material from the
drill unit.
7. Screw the three Knobs (04532) onto the three feed
handles (10569) and then screw the handles into the
hub. Do not overtighten.
8. Your Magnetic Drill was factory adjusted prior to shipping.
Check to make sure that all gib adjustment screws, motor
mount screws, front support bracket screws, and
magnet mounting screws are snug and have not vibrated
loose in transit.
9. Your New Magnetic Drill comes complete with arbor
mounted. The 3/4" diameter arbor bore fits all 3/4" -
shank "12,000-Series" Hougen Cutters.
1. Disconnect power source.
2. Lay drill on its side with feed wheel up to be sure
arbor clears table if unit is in normal operating position.
3. Turn feed handles until cutter mounting set screws are
exposed and then completely remove the set screws.
4. Insert proper pilot into shank end of the cutter.
5. Insert the Cutter until flats on cutter shank are
aligned with set screw holes and is exactly perpendicular
to the axis of set screw hole.
6. Insert Set Screws and tighten.
40222 Set
Screws go here
"12000-Series"
Hougen Cutter
Pilot
