Installation and Wiring
Carefully separate the front half of the thermostat from the back plate by
unscrewing the small screw at the bottom of the thermostat. Carefully unplug the
ribbon connector which is plugged into the front half of the thermostat. Place the
thermostat front half somewhere safe. Terminate the thermostat as shown in the
diagrams below.
Screw the thermostat back plate onto the flush box
Re-connect the thermostat ribbon cable and clip the two halves together.
This product should be installed by
a qualified electrician.
Connect green wires to house earth.
Hotwire
Thermostat
Instructions
LOAD (16A)
FEED
(230 VAC)
Floor Sensor
L
N
Brown wire from Heated T
owel Rail
Brown wire from floor heating element
Blue wire from both floor heating and towel rail.
Power
L 2
L 1
60mm
74mm
82mm
118mm
45mm
Rear View
65mm
Temporary Temperature Override
With thermostat turned off, press and hold OFF for 5 seconds until you can
see -- : -- on LCD.
Manual Mode
Press
MODE
to select Auto/Manual mode. In Manual mode(
), the
thermostat maintains a constant set temperature manually set by the user.
Simply press the temperature and increase it to the required level.
In Auto mode, the thermostat executes the preprogrammed schedules.
Touch the
temperature display, and it will start to flash. Use up or down
buttons to adjust. Press
DONE
to accept, and you will see “Override” above the
temperature display. Thermostat will maintain the new set temperature until the
next programmed event (comfort level). To cancel the override setting, press
Schdl
Lock the Keypad
To lock the keypad, press and hold the “Power” button for for 5 seconds,
you will see a lock symbol . To unlock, repeat the steps above and the lock
symbol will disappear
Reset to Factory Setting