Easy Fix:
Congratulations on the purchase of your easy fix Hotwire Towel Rail
that you will find very easy to install opposed to the difficulty of
other leg fixing designs. You will also find, Easy Fix will securely fix to
the wall long term, opposed to leg fixing designs.
Operation:
Your Hotwire HTR uses minimal electrical power – approximately
that of an average light bulb and will approximately take 15-20
minutes to reach maximum operating temperature.
Hotwire HTR’s are designed for continuous operation, but Hotwire
timing devices are available.
Note: The temperature of your HTR will vary with the ambient
temperature of your room. The HTR is designed to assist the
drying of towels and will normally operate at a temperature that
is too hot to be grasped for an extended time.
Pre-Design & Position:
Please ensure your HTR is installed by a Registered Electrician and
ensure the electrical supply, plug & switch location, and product
location will comply with your local regulations. New Zealand and
Australian electrical wiring requirements stipulate that this
appliance must be wired by a Registered Electrician in accordance
with the current electrical wiring regulations. This appliance must
be fitted with an air gap phase isolation switch which isolates the
phase & neutral in accordance with local wiring regulations. This
product must be used in conjunction with a hard wired switch. For
complete temperature control a wall mounted dimmer switch
(with “off” position) is recommended.
You have a choice of exposed or a concealed power supply cable,
and or, left/right exit position flexibility.
Concealed Power Supply:
A concealed wiring adapter kit is included. If you have access to
the wall cavity the kit allows you to conceal the electrical supply
cable for a more visually appealing installation.
Exposed Power Supply:
By connecting the 3-pin plug supplied to the power cable you
can connect your HTR to the nearest power point. The power
supply cable will exit the bottom bracket.
Guarantee:
This HTR carries a 5 year warranty against defects due to faulty
workmanship or materials from the date of purchase. In the event
of a defect in the product, it should be returned with the sales
receipt to the retailer from whom it was purchased. Under the
guarantee the defective product will be repaired or replaced at
the Suppliers option, excluding costs of disconnection,
reconnection, and freight that are the responsibility of the owner.
This guarantee does not cover any damage to the product caused
by misuse, neglect, accident, nor in violation of the
Manufacturer’s instructions, or any damage, loss or injury arising
as a consequence of the use of the product.
Installation:
Applicable to all ladder models.
Contents:
1 Ladder Towel Rail Frame
1xTop mounting bracket/legs & bracket cover with fixing screws.
1xBottom mounting back bracket/legs & bracket with
fixing screws.
4xbracket wall M5 x 50mm fixing screws
1xElectrical supply cable and 3-pin plug
Product Inspection:
Prior to installation please ensure the product is to your
satisfaction. Once installed the Supplier cannot be responsible for
defects in the product finish. This product is not intended for use
by young children or infirmed persons without supervision.
Young children should be supervised to ensure they do not play
with the product. To minimize a hazard for young children, this
appliance should be installed so that the bottom rail is 600mm
above the floor. If the supply cord is damaged it must be replaced
by the Manufacturer, it’s service agent, or similarly qualified
persons in order to avoid hazard.
Installation:
This HTR must be installed by a Registered Electrician and in
accordance with local and National electrical codes. We
recommend the HTR be installed vertically on a flat and uniform
wall, and where possible into studs or other suitable anchor
material. If fixing to hollow cavity walls, toggle anchors (not
those supplied) or similar devices must be used.
Position the HTR so the power plug and mains power point are
easy accessible closest to the floor. Avoid the supply cable coming
into contact with the heated parts of the towel warmer. Do not
plug the HTR to the power supply or turn on until the unit
installation is completed.