Hotronix Sport Ball Heat Press Manual / 2016-09-28a / pg 2 of 4
Part Identification
Initial Setup
General Guidelines:
To avoid burns, do not touch the heated platen during use.
Keep hands clear of the upper platen of the press during platen lock down as the pressure may cause injury.
Press should be placed on a sturdy, suitable stand at least 36”L x 24”W x 29”H.
Work area must be kept clean, tidy and free of obstructions.
This guide is created with the user in mind. Carefully follow the step-by-step instructions for best results:
1.
Connect the power cord into a properly grounded 120 volt electrical outlet with a minimum 10 amp rating.
If used, a minimum 14-gauge extension cord is required. Short, heavy-duty cords are recommended.
Circuits powering other high demand equipment should not be used.
Power supply cord must be disconnected before cleaning or servicing press.
2.
Raise the lift handle to the UP position.
When not in use, lift handle should remain in the UP position to extend the life of the gas springs.
3.
Turn the Power Switch to the ON position
CAUTION: Failure to follow these instructions will cause:
1.
Erratic controller functions
2.
Inaccurate displays and slow heat-up.
3.
The circuit breaker to disengage.
Control Panel
Adjustment
Handle
Lift Handle
(DOWN)
Upper Platen
(Heater)
Lift Handle (UP)
Ball Mount
Power Switch
Power Inlet
Circuit
Breaker
