12
GB
Switc
hing
the
appliance
off
Disconnect your appliance from the electricity
supply before carrying out any work on it.
Cleaning the appliance
The stainless-steel or enamel-coated external
parts and the rubber seals may be cleaned using
a sponge that has been soaked in lukewarm water
and neutral soap. Use specialised products for
the removal of stubborn stains. After cleaning,
rinse and dry thoroughly. Do not use abrasive
powders or corrosive substances.
The inside of the oven should ideally be cleaned
after each use, while it is still lukewarm. Use hot
water and detergent, then rinse well and dry with
a soft cloth. Do not use abrasive products.
All accessories - with the exception of the sliding
racks - can be washed like everyday crockery,
and are even dishwasher safe.
We recommend that detergents are not sprayed
directly onto the control panel, but that a sponge
is used instead.
N
ever use steam cleaners or pressure cleaners on
the appliance.
Cleaning the oven door
Clean the glass part of the oven door using a
sponge and a non-abrasive cleaning product, then
dry thoroughly with a soft cloth. Do not use rough
abrasive material or sharp metal scrapers as these
could scratch the surface and cause the glass to
crack.
F
or more thorough cleaning purposes, the oven door
may be removed:
1. Open the oven door fully
(
see diagram
).
2.
L
ift up and turn the small
levers located on the two
hinges (
see diagram
).
3
. Grip the door on the two
external sides and close it
approximately half way.
Unlock the door by pressing
on the clamps
F
, then pull the
door towards you, lifting it out
of its slot (
see diagram
). To
replace the door, reverse this
sequence.
I
n
s
p
e
c
t
i
n
g
t
h
e
s
ea
l
s
Check the door seals around the oven regularly. If
the seals are damaged, please contact your nearest
After-sales Service Centre (
see Assistance
). We
recommend that the oven is not used until the seals
have been replaced.
R
eplacing the light
b
ul
b
To replace the oven light bulb:
1. Remove the glass cover using a screwdriver.
2. Remove the light bulb and replace it with a similar
one: Wattage 15 W, cap E 14.
Replace the glass cover, making sure the seal is
positioned correctly (
see diagram
).
C
a
r
e
an
d
m
a
i
ntenan
c
e
F
F
All manuals and user guides at all-guides.com
