Hotpoint NMBL 19 Series, Operating Instructions Manual

Page: 8 / 16

8
GB
Using the freezer to its full potential
• Use the FREEZER OPERATION knob to adjust the
temperature (see Description).
• Do not re-freeze food that is defrosting or that has already
been defrosted. These foods must be cooked and eaten
(within 24 hours).
• Fresh food that needs to be frozen must not come into
contact with food that has already been defrosted. Fresh
food must be stored in the top FREEZER and STORAGE
compartment where the temperature drops below -18°C and
guarantees rapid freezing.
• Do not place glass bottles which contain liquids, and which
are corked or hermetically sealed in the freezer because
they could break.
• The maximum quantity of food that may be frozen
daily is indicated on the plate containing the technical
properties located on the bottom left side of the refrigerator
compartment (for example: Kg/24h: 4).
• To freeze (if the freezer is already operating): press the rapid
freezing SUPER FREEZE button (corresponding yellow
indicator light illuminates), insert the food and close the door.
The function is disabled automatically after 24 hours or when
optimal temperatures have been reached (indicator light goes
out);
! To avoid blocking the air circulation inside the freezer
compartment, it is advisable not to obstruct the ventilation holes
with food or containers.
!
Do not open the door during freezing.
! If there is a power cut or malfunction, do not open the freezer
door. This will help maintain the temperature inside the freezer,
ensuring that foods are conserved for at least 9 -14 hours.
Maintenance and care
Switching the appliance off
During cleaning and maintenance it is necessary to disconnect
the appliance from the electricity supply:
1. set the FREEZER OPERATION knob on
2. pull the plug out of the socket
! If this procedure is not followed, the alarm may sound. This
alarm does not indicate a malfunction. To restore normal
operation, it is sufficient to set the FREEZER OPERATION knob
on the desired value. To disconnect the appliance, follow point
1 and 2.
Cleaning the appliance
• The external and internal parts, as well as the rubber seals
may be cleaned using a sponge that has been soaked in
lukewarm water and bicarbonate of soda or neutral soap. Do
not use solvents, abrasive products, bleach or ammonia.
• The removable accessories may be soaked in warm water
and soap or dishwashing liquid. Rinse and dry them
carefully.
• The back of the appliance may collect dust which can be
removed by delicately using the hose of a vacuum cleaner
set on medium power. The appliance must be switched
off and the plug must be pulled out before cleaning the
appliance.
Avoiding mould and unpleasant odours
• The appliance is manufactured with hygienic materials which
are odour free. In order to maintain an odour free refrigerator
and to prevent the formation of stains, food must always be
covered or sealed properly.
• If you want to switch the appliance off for an extended
period of time, clean the inside and leave the doors open.
Replacing the l Odour filter
The filter should be replaced after approximately 6-8 months
from when it is activated. This period may vary depending
on the type of food that is stored. For information on where a
replacement filter may be purchased, contact Assistance (see
Assistance). To replace the filter, follow the instructions (see
diagrams
A and B ).
Holiday function
To minimise energy usage when on holiday, it is not necessary
to switch the appliance off. The appliance has a function
which allows it to maintain the temperature of the refrigerator
compartment at approximately 12°C (which can also be used
to conserve make-up and beauty products). The freezer
temperature must be set to the minimum value in order to
preserve the food.
To enable the function: set the REFRIGERATOR OPERATION
knob on
.
A double acoustic signal informs you when it has been
enabled. A single acoustic signal informs you when it has been
disabled.
Replacing the light bulb
To replace the light bulb in the refrigerator compartment, pull
out the plug from the electrical socket. Follow the instructions
below.
Access the light bulb by removing the cover as indicated in the
diagram. Replace it with a similar light bulb within the power
range indicated on the cover (10 W, 15 W or 25 W).
1
2