2
GB
Installation
ning the adjustable front feet
(see figure);
the
angle of inclination, measured according to the
worktop, must not exceed 2°.
Levelling your appliance correctly will provide
it with stability and avoid any vibrations, noise
and shifting during operation. If it is placed on
a fitted or loose carpet, adjust the feet in such
a way as to allow enough room for ventilation
beneath the washing machine.
Electric and water connections
Connecting the water inlet hose
1. Connect the supply
pipe by screwing it to
a cold water tap using
a 3/4 gas threaded
connection
(see figu-
re).
Before performing the
connection, allow the
water to run freely un-
til it is perfectly clear.
2. Connect the other
end of the water inlet
hose to the washing
machine,
screwing it onto the
appliance’s cold water
inlet, situated on the
top right-hand side on
the rear of the applian-
ce (
see figure).
3. Make sure there are no kinks or bends in the
hose.
!
The water pressure at the tap must be within
the values indicated in the Technical details
table
(on the page 5).
!
If the water inlet hose is not long enough,
contact a specialist store or an authorised
serviceman.
!
Ensure that the supply taps are allowing wa-
ter through. Old taps may seize in the closed
position and thus prevent water reaching the
machine.
!
Never use second-hand or old inlet hoses;
use the products supplied with the machine.
!
Keep this instruction manual in a safe place
for future reference. Should the appliance be
sold, transferred or moved, make sure the
instruction manual accompanies the washing
machine to inform the new owner as to its
operation and features.
!
Read these instructions carefully: they contain
vital information on installation, use and safety.
Unpacking and levelling
Unpacking
!
This is a separate
part of the polystyre-
ne base and should
be removed with the
base.
!
IMPORTANT check
when unpacking
your machine.
1. Unpack the washing machine.
2. Check whether the washing machine has
been damaged during transport. If this is the
case, do not install it and contact your retailer.
3. Remove the 4 pro-
tective screws and
the rubber bush with
the respective spacer,
situated on the rear of
the appliance (see also
the installation leaflet).
4. Seal the gaps using
the plastic plugs provi-
ded.
5. Keep all the parts:
you will need them again if the washing machi-
ne needs to be moved to another location.
!
Packaging materials are not children’s toys.
Levelling
Your machine may make a considerable
amount of noise if the two front feet have not
been adjusted correctly.
1. Install the washing
machine on a flat sturdy
floor, without resting it
up against walls, cabi-
nets or anything else.
2. If the floor is not per-
fectly level, compensa-
te for any unevenness
by tightening or loose-
