15
Routine Maintenance and Cleaning
Before each operation, disconnect the cooker from the
electrical supply. To ensure that the appliance stands the
test of time, it must be thoroughly cleaned frequently, keep-
ing in mind that:
•••••
do not use steam equipment to clean the appliance
•
the enamelled parts and the self-cleaning panels, where
present, are washed with warm water without using any
abrasive powders or corrosive substances which could
ruin them;
•
the inside of the oven should be cleaned fairly often
while it is still warm, using warm water and detergent
followed by careful rinsing and drying;
•
the flame spreaders should be washed frequently with
hot water and detergent, taking care to eliminate any
scale;
•
In cookers equipped with automatic lighting, the termi-
nal part of the electronic instant lighting devices should
be cleaned frequently (C) and the gas outlet holes on
the flame spreaders should be checked to make sure
they are free of any obstructions;
•
stainless steel may become marked if it comes into
contact with very hard water or harsh detergents (con-
taining phosphorous) for long periods of time. After
cleaning, rinse and dry thoroughly. It is also recom-
mended that any remaining drops of water be dried;
•
On models with glass covers, the covers should be
cleaned with hot water; the use of rough cloths or
abrasives is to be avoided
N.B.: Avoid closing the cover while the gas burners
are still warm. Remove any liquid from the lid be-
fore opening it.
Important: periodically check the wear of the gas hose
and substitute it if there are any defects; we recommended
changing it every year.
Replacing the oven light bulb
•
Before any operation, disconnect the hob from the elec-
trical supply by pulling out the plug or using the switch
that connects the oven to the electricity mains.
•
Using a narrow, thin object (screwdriver, spoon handle,
etc.), remove the glass lid.
•
Remove the lamp and replace it with one that has the
same properties:
- Voltage: 230/240 V
- power 15W
- E 14 cap
•
Replace the glass cover taking care to position the seal
correctly.
coperchio
guarnizione
lampadina
cavità
Gas tap maintenance
The taps may jam in time or they may become difficult to
turn. If so, the tap itself must be replaced.
N.B.: This procedure must be performed by a techni-
cian authorised by the manufacturer.
Summary of Contents for EG600P
Page 16: ...16 NOTES...
Page 17: ......
