7
Installation
These instructions are intended for the qualified technician
installing the appliance in order to insure that the installation,
adjustments and maintenance procedures are performed
correctly and comply with the regulations currently in effect.
Important: the appliance must be disconnected from
the power supply before making any adjustments or
performing any maintenance, etc.
The appliance is Type Y and therefore can be installed
alongside of cabinets which are higher than the surface of
the worktop. The following precautionary measures should
be observed in order to ensure proper installation:
a) Hoods must be installed in compliance with the required
specifications contained in the instruction manual for the
hood itself.
b) The appliance can be installed on any counter top as
long as it is 600 mm or more in width and resistant to
temperatures of up to 100°C. The dimensions and the
position of the hole are shown below.
These measurements must absolutely be observed in
so far as improper installation can cause the surrounding
surface areas to overheat. It is recommended that the
appliance be installed at a distance of at least 55 mm
from the back wall or other vertical surfaces to ensure
that the air circulates properly over the cooking area and
to avoid overheating the surrounding surfaces. A seal or
gasket is provided with the appliance, make sure that it
adheres properly to the bottom part of the appliance
frame. The seal must be fitted properly around the
entire perimeter of the appliance and especially along
the corners in order to create a seal between the
work top and the appliance itself so as to prevent
spills or splashes from leaking into the cabinet below.
The appliance must be fitted into the worktop using the fixing
clamps - see diagram.
Very important
It is essential to install the appliance on a totally flat surface.
Any damage caused by incorrect fitting may alter the
characteristics or impair performance.
Insert the appliance into the hole, pressing firmly around the
frame to make it adhere to the counter top.
Note: If the appliance is installed above a built-in oven, it is
preferable that the oven be installed in such a way that it is
set on two strips of wood; if the oven is installed on a
continuous base, there must be an opening in the back of
at least 45 x 560 mm.
The built-in oven must be equipped with a forced air
cooling system.