Care and Cleaning
Cleaning—Outside
Solid
state monitor system
panels. Clean the
on the
outside
inside the freezer
compartment door with soft,
cloth lightly dampened with
water. Do not use cleaning sprays
or
amounts of water—the
liquid
run down
the control mechanisms.
The water and
dispenser
spill shelf
be wiped dry
immediately to prevent spotting,
Water left on the
may leave
deposits that you
remove by
soaking in undiluted vinegar.
can also use a paste of
non-precipitating
softener
(such as
brand) and water,
or one teaspoon of citric
powder per pint of hot tap water.
Soak until the deposit disappears or
becomes loose enough to rinse
away. Usually
minutes soaking
time is adequate. Avoid using wax
on the spill shelf and trim.
The door handles and trim can
be cleaned with a cloth dampened
with a solution of mild liquid
detergent
water.
Dry with a soft cloth. Don’t use
wax on the door handles and trim.
Keep the finish clean. Wipe with
a clean cloth lightly dampened
with kitchen appliance wax or mild
liquid
detergent. Dry
and polish with a clean, soft cloth.
Do not wipe the refrigerator with
a soiled
cloth or wet
towel. These may leave a residue
that can erode the paint. Do not use
scouring pads, powdered cleaners.
bleach or cleaners containing bleach
because these products can scratch
and weaken the paint finish.
the paint finish. The
on the outside of the refrigerator is a
high quality, baked-on paint
With proper care, it will stay
rust-free for years.
Apply a coat of kitchen/appliance
wax when the refrigerator is new
and then at least
year.
Appliance Polish Wax Cleaner
(Cat. No.
is available
from
Appliance Parts
Marts.
Cleaning—Inside
Inside the fresh food and freezer
compartments should be cleaned at
least once a year. Unplug the
refrigerator before cleaning. If
this is not practical, wring excess
moisture out sponge or cloth
when cleaning around switches,
lights or controls,
Use warm water and baking soda
solution—about a tablespoon of
baking soda to a quart of water. This
both cleans and neutralizes odors.
Rinse thoroughly with water and
wipe dry.
Other parts of the
including door gaskets, meat and
vegetable drawers,
storage
bin and all plastic parts-can be
cleaned the same way. Do not use
cleansing powders or other abrasive
cleaners.
To
prevent odors,
an open box of baking soda in the
rear of the refrigerator, on the top
shelf. Change the box every three
months. An open box of baking
soda in the freezer will absorb
stale freezer odors.
Do not wash any plastic parts
from your refrigerator in your
automatic dishwasher.
Drain opening in freezer
compartment. During yearly
cleaning, remove bottom freezer
basket and flush a solution of
baking soda (one teaspoon) and two
cups of hot (not boiling) water
through the drain line with the help
of a meat baster. This will help
eliminate odor and reduce the
likelihood
a clogged drain line.
If drain becomes
clogged, use a
-—-.
meat baster and
‘“
-
water solution to
force the clog
through the
drain line.
Continue flushing until line is clear,
then empty and replace the defrost
water pan immediately.
Behind Refrigerator
Care should be taken in moving
your refrigerator away from the
wall. All types of floor coverings
can be damaged, particularly
cushioned coverings and those
with embossed surfaces. Pull the
refrigerator straight out and return it
to position by
it straight in.
Moving your refrigerator in a side
direction may result in damage to
your floor covering or refrigerator.
Condenser
The condenser is located behind
the base grille. For most efficient
operation you need to keep the
condenser clean. Remove the base
grille (see page 4) and either sweep
away or vacuum up dust that is
readily accessible. This easy
cleaning operation should be done
at least once a year.
Defrost Water
Pan behind base grille should be
cleaned at least once a year. When
reinstalling pan, firmly push it
ALL THE WAY IN until it stops.
Defrost water pan
17
Summary of Contents for CSX24X
Page 22: ...Noks 22 ...
