9
Electrical Connection
Connecting the supply cord to the electrical mains:
The hob must be connected to the mains by a double pole
mains switch, which must have a minimum 0f 3mm space
between the contacts, correctly fused with a capacity
appropriate to that shown on the hob Rating Plate. All
electrical wiring from the consumer unit to the appliance, via
the switched double pole cooker outlet, must be of an
acceptable type and current rating as above.
The supply cord should conform to BS6004 conductor size
4mm
2
, must be positioned so that no part of it reaches a
temperature of 50°C above room temperature. The electrical
installation must comply with the IEE Regulations, Building
Regulation & local By-Laws.
Before making the connection, make sure that:
•
the limiter switch (fuse) and the residual wiring can support
the appliance load (see the rating plate).
•
the mains system is properly earthed in compliance with
current regulations and provisions.
•
there is easy access to the socket or the double pole
switch after the appliance is installed.
IMPORTANT:
If the hob is installed above a built-in oven, the electrical
connection for the hob must be independent of that for the
oven, both for safety reasons and to facilitate the removal of
the oven for maintenance, repair etc.
Electrical Connection
THIS APPLIANCE MUST BE EARTHED.
The installation procedure must be carried out by a qualified
electrician.
The electrical safety of this appliance is guaranteed only if
the appliance is correctly earthed in compliance with the
standards of electrical safety.
The manufacturer can under no circumstances be considered
responsible for any damage that might occur due to incorrect
earthing of the hob.
The electric hob is not supplied with a power supply cord
because the type of cord used depends on the type of
electrical connection (see following diagram). Open the
terminal box, following the instructions illustrated in the diagram
below:
Voltage and frequency of power supply:
230-240V
50-60Hz
7000W
Supply cable installation
The electric hobs are supplied without a cable.
Use a cable: 4mm
2
•
open the teminal box by removing the "V" screw and
taking off the cover.
Electrical Connections:
1 2 3
4
5
• • •
•
•
•
L
N
•
Fix the cable in place with the "F" cable clamp, close the
lid and fasten it with the "V" screw.
F
V
1
2
3
4
5
2
1
1
2
3
4
5
V
IMPORTANT POINTS:
Your hob is supplied with a special connection cable.
If ever the cable is damaged it should be replaced by an
authorised service engineer only.
Disconnect the hob form the electrical supply before any
work is carried out.
