8
Installation
The following instructions are intended for a qualified installer
so that the installation and maintenance proceedures may
be followed in the most professional and expert manner
possible.
Important: Unplug the electrical connection before
performing any maintenance or regulation upkeep work.
Installation of built-in hobs
The electric hobs are prepared with protection degree against
excessive heating of Y type, it is therefore possible to instal
them next to furniture which is higher than the worktop. For a
correct installation of the hob the following precautions must
be followed:
a) The hob may be located in a kitchen, a kitchen/diner or
bed sitting room, but not in a bathroom or shower room.
b) The hoods must be installed according to the requirements
in the hood handbook.
c) The dimensions of the cutout for the appliance must be
those indicated in the figure. Clamps are provided to fasten
the hob to worktops measuring from 20 to 40 mm in
thickness. To fasten the hob securely, it is recommended
that all the clamps be used.
555 mm
55 mm
475 mm
Fastening Clamps - Assembly Diagram
20
30
Clamp Position for
Clamp Position for
H=20mm top
H=30mm top
Front
40
Clamp Position for
H=40mm top
Back
N.B: Use the clamps contained in the "accessory kit."
d) In case a wooden panel should be fitted under the top
for insulation, it will have be fitted at a minimum distance
of 20 mm from the inferior part of the top.
Important: When installing the hob on a built-in oven, the
oven should be placed on two wooden strips; in the case
of a joining cabinet surface, remember to leave a space of
at least 45 x 560 mm at the back.
When installing on a built-in oven without forced ventilation,
ensure that there are air inlets and outlets for ventilating the
interior of the cabinet adequately. Assembly examples are
given in figs.
560 mm.
45 mm.
