background image

EN

7

TEMPERATURE 

button

WASH CYCLE 

SELECTOR

 

knob

OPTION 

buttons with 

indicator lights

DOOR LOCKED

 

indicator light

START/PAUSE

 

button with indicator 
light

WASH 

CYCLE 
PHASE

 

icons

 

DELAY 
TIMER

 

button

CHILD LOCK 

button 

with indicator light

Button with

 

ON/OFF 

indicator light

ECO 

indicator light

OPTION 

buttons with 

indicator lights

TEMPERATURE

indicator light

SPIN

 

indicator  
light

DELAY TIMER 

 

indicator light

Control panel

Button with 

 

ON/OFF

 indicator light: press this briefly 

to switch the machine on or off. The green indicator light 
indicates that the machine is switched on. To switch off the 
washing machine during the wash cycle, press and hold 
the button for approximately 3 seconds; if the button is 
pressed briefly or accidentally the machine will not switch 
off. If the machine is switched off during a wash cycle, this 
wash cycle will be cancelled.

WASH CYCLE SELECTOR

 

knob: may be turned in 

either direction. To select the most suitable wash cycle, 
please refer to the 

“Table of wash cycles”.

The knob will not move during the wash cycle.

TEMPERATURE

 

 button: press to modify or exclude 

the temperature setting; the value will be identified by the 
indicator lights above it 

(see “Running a wash cycle”).

SPIN SPEED CYCLE

 

 button: press to modify or 

exclude the spin cycle; the value will be identified by the 
indicator lights above it 

(see “Running a wash cycle”).

DELAY TIMER

   button: press to set a DELAY TIMER 

for the selected wash cycle; the delay time will be identified 
by the indicator lights above 

(see “Running a wash cycle”).

OPTION

 buttons with indicator lights: press to select the 

available options. The indicator light corresponding to the 
selected option will remain lit 

(see “Running a wash cycle”).

WASH CYCLE PHASE

 icons: these illuminate to indicate 

the progress of the wash cycle (Wash 

 – Rinse   – Spin 

 – Drain 

).

The text 

 lights up when the cycle is complete.

START/PAUSE 

button with indicator light: when the green 

indicator light flashes slowly, press the button to start a 
wash cycle. Once the cycle has begun the indicator light 
will remain lit in a fixed manner. To pause the wash cycle, 
press the button again; the indicator light will flash in an 
orange colour. If the “Door locked” 

 indicator light is 

switched off, the door may be opened. To start the wash 
cycle from the point at which it was interrupted, press the 
button again.

DOOR LOCKED

 

 indicator light: indicates that the 

porthole door is locked. To open the door, pause the wash 
cycle (see “

Running a wash cycle

”).

CHILD LOCK

 

 button with indicator light: to activate 

or deactivate the CHILD LOCK, press and hold the button 
for approximately 2 seconds. when the indicator light 
is illuminated, the control panel is locked. This means it 
is possible to prevent wash cycles from being modified 
accidentally, especially where there are children in the 
home.

ECO

 indicator light: the 

 icon lights up when, after 

altering the washing parameters, an energy saving of 
at least 10% is made. Furthermore, before the machine 
enters “Standby” mode, the icon will light up for a few 
seconds; when the machine is switched off the estimated 
energy saving will be around the 80% mark.

SPIN SPEED

 

button

Summary of Contents for AQUALTIS AQ9L 292 I

















Reviews: