25
TROUBLESHOOTING GUIDE
If the dishes are not warm enough, check
that:
• the appliance is switched on
• the right temperature has been set
• ventilation openings are not covered by
plates or large bowls
• the dishes were not heated long enough.
• the mains switch has not been turned off.
Different factors affect the warming time, for
example:
- material and thickness of the dishes, the
load and its arrangement, temperature
setting.
- The optimum times for warming dishes
vary, therefore it is advisable to do tests to
establish them according to needs.
AFTER-SALES SERVICE
Before contacting the After-Sales Service:
1. See if you can solve the problem yourself
with the help of the “Troubleshooting
guide”.
2. Switch the appliance off and then on again
to see if the problem has been eliminated.
For the following problems, contact a
qualified technician or the After-Sales
Service:
If the dishes do not get warm:
• the electrical power cable could be
disconnected or damaged.
If the dishes get too hot:
• the temperature controller could be faulty.
The On/Off switch does not activate when
the appliance is turned on:
• the switch control indicator is faulty.
If the problem persists after the above
checks, contact the nearest After-Sales
Service.
Always specify:
• a brief description of the fault;
• the warming drawer type and exact model;
• the Service number (the number after the
word Service on the data plate), located on
the outer right edge of the drawer runner.
The Service number is also given in the
warranty booklet;
• your full address;
• your telephone number.
If any repairs are required, contact an
authorized After-Sales Service Center (to
ensure the use of original spare parts and
correct repairs). Failure to comply with these
instructions can compromise the safety and
quality of the product.
DECLARATION OF CONFORMITY
• This warming drawer is intended to come
into contact with foodstuffs and complies
with Regulation (EC) no. 1935/2004.
• It is designed to be used only as an
appliance for warming dishes or for keeping
them hot. Any other use (e.g. for room
heating) is deemed improper and therefore
hazardous.
• It has been designed, manufactured and
marketed in conformity with:
- the safety objectives of “Low Voltage”
Directive 2006/95/EC (which replaces
73/23/EEC as amended);
- the protection requirements of “EMC”
2004/108/EC.
