21
EN
Notes:
Optimum performance levels when using the “Fast" and
"Express” cycles can be achieved by respecting the
specified number of place settings.
To reduce consumption even further, only run the dishwasher
when it is full.
Note for Test Laboratories:
for information on comparative
EN testing conditions, please send an email to the following
address: [email protected]
Special wash cycles
and Options
Wash options*
The OPTIONS may only be set, changed or reset after
the wash cycle has been selected and before the Start/
Pause button has been pressed.
Only the options which are compatible with the type of wash
cycle set may be selected. If an option is not compatible
with the selected wash cycle
(see Table of wash cycles)
, the
corresponding symbol flashes rapidly 3 times.
If an option is selected which is not compatible with another
(previously selected) option, it will flash 3 times and switch
off, while the most recently selected option will remain active.
To deselect an option which has been set by mistake, press
the corresponding button again.
Multi-functional tablets
Option
(Tabs)
This option optimises washing and drying results.
When using multi-functional tablets, press the
MULTI-FUNCTIONAL TABLETS button; the corresponding
symbol will light up. If the button is pressed again, the option
will be deselected.
The “Multi-functional tablets” option results in a
longer wash cycle.
Delayed start Option
It is possible to delay the start time of the cycle by a
period of time between
1
and
24
hours:
1. Select the desired wash cycle and any other options
required; press the DELAYED START button. The indicator
light will go on. Use the same button to select when the wash
cycle will start (h01, h02 etc.)
2. Confirm the selection using the START/PAUSE button to
start the countdown.
3. Once this time has elapsed, the DELAYED START indicator
light goes off and the wash cycle begins.
To deselect the DELAYED START option, press the DELAYED
START button until the text
OFF
appears.
The Delayed Start function cannot be set once a wash
cycle has started.
Half load Option using the upper or lower rack
If there are not many dishes to be washed, a half
load cycle may be used in order to save water,
electricity and detergent. Select the wash cycle and then
press the HALF LOAD button: the indicator corresponding
to the chosen rack lights up and the wash cycle starts only
in the upper or lower rack.
Remember to load the upper or lower rack only, and
to reduce the amount of detergent accordingly.
*
Only available in selected models.
Summary of Contents for LSFF 8M116
Page 82: ...82 KZ ...
Page 83: ...KZ 83 ...
