GB
1
7
THE EQUIPMENT MUST BE EARTHED CORRECTLY.
The hob is designed for operation with an alternating
current at the power supply voltage and frequency
indicated on the data plate (this is located underneath
the hob; alternatively the information may be found at
the end of the instruction manual). Make sure that the
local power supply voltage value is the same as the
value indicated on the data plate. The appliance does
not come with a power supply cable, because the size
of this cable should be determined according to the
type of electrical connection used (see connection
diagram below). Use a H05RR-F-type rubber cable.
Open the terminal board, following the instructions for
the adjacent figure:
To install the power supply cable, follow the instructions
below:
Loosen the cable clamp screw V and the wire
contact screws (fig. 11).
Fix the wires under the screw heads in accordance
with the following diagram.
2
1
1
2
3
4
5
V
Fig.11
Secure the power supply cable by fastening the cable
clamp screw, then put the cover back on.
Electrical
connection
Power supply
voltage
Fuse
Cross-
section
230V -1+N ~ 50Hz
32* A
4 mm²
400V 2+N ~ 50Hz
32 A
4 mm²
400V -3+N ~ 50Hz
25 A
2.5 mm²
230V -2 ~ 50Hz
32* A
4 mm²
230V -3 ~ 50Hz
25 A
2.5 mm²
230V -2+2N ~
50Hz
25* A
2.5 mm²
*Application of the simultaneity coefficient in
compliance with the relevant standard.
E
lectrical
c
o
nnecti
o
n
Connecting the power supply cable to the mains
Find a plug which is suitable for the load indicated on
the data plate and fit it onto the cable. The appliance
must be directly connected to the mains using an
omnipolar switch with a minimum contact opening of 3
mm installed between the appliance and the mains.
The switch must be suitable for the load indicated and
must comply with current electrical regulations (the
earth wire must not be interrupted by the switch). The
supply cable must not be placed in areas where any
part of it could reach temperatures higher than 50°C.
Before connecting the appliance to the power supply,
make sure that:
The modulating valve and the electricity supply can
withstand the maximum power of the appliance (see
the data plate for details);
The electricity supply system is earthed correctly, in
compliance with current laws and regulations;
The power socket or omnipolar switch may be reached
easily once the hob has been installed.
TE
C
H
N
I
C
A
L
F
EATU
R
ES
:
Voltage and Frequency 230/400 V ~ 50 Hz
Max. absorption: 10000 W
