18 of 28
Service Manual UK
Indesit
Company
English
E
Console PCB
1.
Remove the console panel (D).
2.
Remove the wiring plug - taking note of position.
3.
Remove the four securing screws.
F
Timer Knob, Programme Dial & Potentiometer
1.
Push the timer knob to release it to the operating (out position) then pull knob firmly. Note: this knob
has keyed slots to determine position for replacement.
2.
Remove two screws securing the selector switch plate and carefully unclip the programme dial.
G
Option Knobs & Potentiometer
1.
Push the knobs to release them to the operating (out position) then pull the knob firmly from the 'D'
shaft.
2.
Carefully unclip the relevant potentiometer.
H(a) Pressure Switch
1.
Remove the table top (A).
2.
Disconnect the wiring connection block and pressure hose.
3.
Carefully unclip the bracket from the cabinet side and then unclip the switch from the bracket.
H(b) Front Panel
1.
Remove the table top (A), dispenser drawer (C) and console panel.
2.
Remove the door seal restraint (I) and door interlock (J).
3.
Grip the appliance kickstrip at both ends and pull it off in a forward direction.
4.
Remove 4 front panel fixing screws (2 bottom, 2 top).
5.
Slide the dispenser housing backwards so that it clears the console backplate opening.
6.
Lift the front panel upwards to disengage the four cabinet fixing pegs and lift off.
I
Door Seal & Restraint:
1.
Door Seal to Front Panel Fixing
The door seal is fixed to the cabinet front panel by a wire clamp and a small spring. The spring is
normally at the bottom of the door.
Carefully place a small screwdriver into one of the lugs of the spring and by stretching the spring
the wire band can be removed.
2.
Drum Fixing
The door seal is fixed to the drum with a zipper retainer. After removing the front panel (Hb) remove
the zipper as shown in Fig. 1 overleaf.
