22 of 26
Service Manual UK
Indesit
Company
English
V
Heater Box / Drum Assembly
1
Disconnect cable connections to motor, heater, thermistor and thermostat / thermal fuse cable.
2
Disconnect tie-wrap fixing heater box assembly to the door seal.
3
Disconnect filter flushing hose (if fitted).
4
Remove five Torx T30 screws fixing heater box assembly to outer drum and lift away.
Note:
On re-assembly fix screws in front to rear order, torque setting for screws 12 Nm.
V(a)Fan Motor
1
Disconnect cables to the motor, heater, thermistor and thermostat.
2
Remove the seven Torx T20 screws holding top and bottom sections and lift top section away.
3
Remove fan from motor shaft by unscrewing 11 mm nut.
Note; this is Left Hand Thread.
4
Remove the four fixing screws and release motor.
Note:
On re-assembly the fan must have a clearance of approximately 2 - 3 mm from the inside of
the top section. Use nutlock 242 (Part No. C00981009) on thread of fan nut.
V(b)Heater
1
Remove top section as in V (a) 1 - 2.
2
Release heater by removing the two 19 mm nuts.
V(c) Thermistor
1
Remove the table top (A).
2.
Remove the screws holding the thermistor.
3.
Disconnect the wiring connection and lift clear.
Thermal Fuse Cable
To remove: Disconnect the thermal fuse from the heater / loom end. Remove the thermal fuse
cable clamp.
W(a) Drum Assembly
1.
Remove the table top (A).
2.
Remove the top balance weight (Nb).
3.
Remove heater box assembly (V).
4.
Remove the dispenser drawer (C).
5.
Remove the console panel (D).
6.
Remove the dispenser (S).
7.
Remove the front panel (J).
8.
Remove the lower balance weight (Na).
9.
Remove the lower rear access panel (B).
10. Remove the motor (M).
11. Detach the drum from the damper units by removing the two plastic pegs using special
tool Part No. C00141734.
12. Remove the sump hose fixing clip and detach the sump hose from the sump chamber.
13. Disconnect heater / thermistor wiring and release the wiring harness from the drum clips.
