31
Car
e and Cleaning
Anti-T
ip Device
Wall behind range
Adjacent
cabinet
or final
location
of range
side panel
Outside edge of
bracket to be flush
with left or right side
of range
Make sure
leg leveler
engages slot
ANTI-TIP DEVICE
WARNING
• All ranges can tip.
• Injury could result.
• Install the Anti-tip device
packed with the range.
• See the Installation
Instructions.
STABILITY DEVICE INSTALLATION INSTRUCTIONS FOR BRACKET KIT NO. 342473
Tools needed:
• Phillips head screwdriver
• 1
3
⁄
8
″
open end or adjustable wrench
The bracket attaches to floor or wall to hold either the
right or left rear leg leveler. If fastening to the floor,
be sure that the screws do not penetrate electrical
wiring or plumbing. If this cannot be determined, use
shorter screws that will not penetrate through
flooring.
The bracket is packed inside the oven. Remove and
follow the instructions below.
1. Decide whether the bracket will be installed on the
right or left side of the range location.
2. If the bracket side of the range is adjacent to a
cabinet, place the bracket against back wall and
cabinet as shown in Figure 1.
If there is no adjacent cabinet, determine where
the location of the range side (painted outside
panel) will be. Place the bracket with its outside
edge at this location and against the back wall.
See Figure 1.
Attachment to wall
Wall Plate
Bracket
Screw must enter wood
or metal
Fig. 1
Summary of Contents for RB755
Page 34: ...34 NOTES...
